does it do an automatic brim?

Share your experience with UP mni 2!
Post Reply
Posts: 1
Joined: Mon May 21, 2018 2:23 pm

does it do an automatic brim?

Post by UNArte » Mon May 21, 2018 2:44 pm

Hey all,

I'm just starting using the printer and upstudio. i did a few small prints. i got this brim for a model that is not all the way around and it is not made to be snapped off. any idea if this is some automatic feature? this didn't happen for some small cubes (one imported and one made within upstudio).

20180521_173443.jpg (1.05 MiB) Viewed 1375 times
20180521_173433.jpg (683.42 KiB) Viewed 1375 times
20180521_173428.jpg (740.29 KiB) Viewed 1375 times

Post Reply