Page 1 of 1

Nozzle material

Posted: Tue Mar 27, 2018 5:13 pm
by YoHidden
Hi there,

I'm willing to give a try to the filament PETG-Carbon, just to se if I can avoid warping effect wth ABS. I've seen in the Up mini 2 specs that this is one of the compatible materials for filaments. But I've also seen that brass or bronze nozzles should not be used with this kind of abrasive materials.

So my question is... what's the material of the nozzle that comes with the Up mini 2 out of the box ?

Thanks.

Re: Nozzle material

Posted: Wed Mar 28, 2018 11:46 pm
by Tiertime-Elaine
Hi YoHidden´╝î

It is made of brass.
We suggest you use stainless steel nozzle for printing PETG- Carbon.

Elaine

Re: Nozzle material

Posted: Fri Mar 30, 2018 10:26 am
by YoHidden
Thanks for the reply. And just to be sure... the nozzle diameter is 0.4mm ?

Re: Nozzle material

Posted: Fri Mar 30, 2018 3:16 pm
by Owen Sparks aka Marksman
Yes, M6 fine female.

Re: Nozzle material

Posted: Tue Apr 03, 2018 2:23 pm
by YoHidden
Is it the same nozzle type used for UP Plus, UP Mini and the Up Box (manufactured after March 2015) ?

Re: Nozzle material

Posted: Tue Apr 03, 2018 10:22 pm
by Owen Sparks aka Marksman
Mini 2, UPBOX and UPBOX+ are all the same, I'm afraid I can't comment on the earlier models.

O.S.

Re: Nozzle material

Posted: Fri Jun 08, 2018 6:50 am
by tiertimefreya
PLUS MINI BOX (manufactured after March 2015)
All brass nozzles, model is V2

https://www.ebay.com/itm/282941616967