New Owner

Share your experience with UP mni 2!
Post Reply
sjhawkins
Posts: 3
Joined: Sat Jan 07, 2017 2:21 pm

New Owner

Post by sjhawkins » Sat Jan 07, 2017 2:26 pm

Hi All

I've just purchased my UP mini 2 and have been playing with it and so far been very impressed. I wanted a printer that would print abs without any hassle and so far all is good

I do own another 3D printer which I really struggle to print ABS with

Couple of quick questions.

Should I be able to connect to my printer over Wifi in UP studio?

First couple of prints I've really struggled to separate from board and also remove the support material. Are there any good guides to UP studio around?

Thanks

Steve

Post Reply