Page 1 of 1

Calibrating nozzle MINI2

Posted: Wed Sep 14, 2016 5:09 pm
by zeeb84
Manual says that clicking on the "+" or the "-" button to calibrate nozzle height will adjust the BED accordingly. The LCD screen indicates that to be adjusting the NOZZLE height. My nozzle is slightly too high, and causing the raft to print in loopy fashion. I want to get the nozzle closer to the bed. Am I pushing the "=" or the "-"?

Re: Calibrating nozzle MINI2

Posted: Thu Sep 15, 2016 10:18 am
by tel
+ should move the nozzle closer, - moves it further away

Re: Calibrating nozzle MINI2

Posted: Fri Sep 16, 2016 11:24 am
by zeeb84
Thank you will give it a shot

Re: Calibrating nozzle MINI2

Posted: Mon Oct 03, 2016 3:00 am
by Surge
After leveling, why not use the automatic nozzle height feature?

Re: Calibrating nozzle MINI2

Posted: Tue Oct 04, 2016 6:14 pm
by wackojacko
To set the value just click the new value and you'll hear a beep and that will set it. I think if you print a model from one of the slots, it will use the old value saved with the model.