The thickness of the paper for manual calibration

Share your experience with UP mni 2!
Post Reply
Blokadnik
Posts: 4
Joined: Sun May 27, 2018 9:13 pm

The thickness of the paper for manual calibration

Post by Blokadnik » Sun Mar 24, 2019 10:19 am

Good afternoon.
Tell me what paper thickness is required for manual calibration UP mini 2? Paper for calibration is lost.

bjorn
Posts: 172
Joined: Fri Aug 10, 2018 6:00 pm

Re: The thickness of the paper for manual calibration

Post by bjorn » Sun Mar 24, 2019 2:12 pm

I don't there is a universal answer for that as it will depend on the filament you use, the temperature of both head and bed and how well you want the print to stick.

But you can use any thickness and adjust the bed offset setting after to achieve the adhesion or relieve "elephant foot" after.

To give you an rough idea I think something around 0.1-0.2mm works well for most cases.

bjorn
Posts: 172
Joined: Fri Aug 10, 2018 6:00 pm

Re: The thickness of the paper for manual calibration

Post by bjorn » Wed May 01, 2019 12:37 pm

Just found mine. It was 0.35mm.

Post Reply