Nozzle Digging into Board

Share your experience with UP BOX and UP BOX+
Post Reply
CCNA
Posts: 1
Joined: Wed Dec 13, 2017 5:34 pm

Nozzle Digging into Board

Post by CCNA » Mon Jul 16, 2018 8:25 pm

After clearing the settings and doing an auto-level, which also checks nozzle height, I am having a problem where it seems the nozzle is too low and is digging into the non-stick surface on the print board. I have tried a manual level, but that doesn't seem to be much better. Any thoughts on what to do?

Tiertime-Elaine
Posts: 143
Joined: Wed Dec 20, 2017 4:23 am

Re: Nozzle Digging into Board

Post by Tiertime-Elaine » Thu Aug 23, 2018 7:23 am

Hi CCNA,

Have you checked the value of Nozzle Offset in the software? How to find the: open the software go to UP-> click Print -> you will find the Nozzle offset.

Here's a tutorial of how to calibrate the printer manually: https://www.tiertime.com/9-point-calibration-method/

Hope above helps a bit.

Elanie

Post Reply