"Nozzle too hot" error - Up Box+

Share your experience with UP BOX and UP BOX+
Post Reply
titaniumapple
Posts: 56
Joined: Sun Oct 04, 2015 6:49 am

"Nozzle too hot" error - Up Box+

Post by titaniumapple » Fri Mar 02, 2018 10:01 pm

Hi,

I have a new Up Box+ but it hasn't printed past about 15 layers since I've had it (UP ABS).

I've changed the ribbon cable, extruder PCB and I have sent it to the supplier and they've changed the hot end. They reported it printing for over 6 hours without a problem but I got it back and tried it and it's still stopping about 15 layers in saying 'nozzle too hot' (at a temp of about 126%).

What could be causing this?

Thanks

Owen Sparks aka Marksman
Posts: 610
Joined: Tue Mar 15, 2016 9:56 am

Re: "Nozzle too hot" error - Up Box+

Post by Owen Sparks aka Marksman » Sat Mar 03, 2018 7:19 am

In my opinion that's definitely a hardware problem. I don't think there is anything a user could do wrong that would result in that error.

Owen S.

User avatar
car3less
Posts: 56
Joined: Fri Oct 03, 2014 12:52 pm
Location: Bucharest, Romania
Contact:

Re: "Nozzle too hot" error - Up Box+

Post by car3less » Wed Mar 07, 2018 5:22 pm

This reminds me of my first Up Box that I bought about 3 years ago. It was a disaster. Tiertime changed my printer after 8 months of struggles. Among other problems, the printer was giving this error and aborting midprint. That problem was caused by the extruder block assembly.

Now I have 2 Up Box. And they are pretty good.

Tiertime-Elaine
Posts: 143
Joined: Wed Dec 20, 2017 4:23 am

Re: "Nozzle too hot" error - Up Box+

Post by Tiertime-Elaine » Wed Mar 07, 2018 11:54 pm

Hi titaniumapple,

Make sure all extruder cables have plugged in correctly not loose
Beside, you could contact our tech support by email support(at)tiertime.com for further assistances.

Elaine

Post Reply