UPBOX stops extruding during printing

Share your experience with UP BOX and UP BOX+
Post Reply
Posts: 1
Joined: Wed Feb 01, 2017 2:43 pm

UPBOX stops extruding during printing

Post by baptistebeulque » Wed Feb 01, 2017 3:01 pm

For a few days, when I'm printing something, I've a problem :
The printing starts, and suddendly, the printer stops extruding the filament but the printhead still moving.
And sometimes (but not always) the error B (flashing red) appears during the printing, and the printer stops printing.
What shall I do to fix it ?
Have a nice day.

Posts: 242
Joined: Tue Feb 09, 2016 1:35 pm
Location: Australia

Re: UPBOX stops extruding during printing

Post by tel » Thu Feb 02, 2017 1:13 am

The flashing B is the error message for a Print Head Temperature Error. First make sure both the white ribbon cable and the Rainbow Cable are seated correctly. If they are and the error continues it probably means you will need to replace the white ribbon cable, which is a fairly common fault.

Post Reply