What may cause this?

Share your experience with UP BOX and UP BOX+
User avatar
wackojacko
Posts: 667
Joined: Fri Nov 12, 2010 5:46 am
Contact:

Re: What may cause this?

Post by wackojacko » Fri Apr 01, 2016 7:51 pm

If you are from Australia or New Zealand I can help, otherwise contact who you purchased the UP BOX from and request a replacement X bar.
Another alternative that worked for another forum member was to use two part epoxy on either side of the cog, let it dry for 24 hrs and you'll be back in action!
Bruce
http://www.3DPrintingSystems.com

Need help with your printer, check out our Youtube channel.
https://www.youtube.com/user/3dprinting ... /playlists

Post Reply