So, I've attached a photo of what I meant..
Is there any particular reason that the first layer of a model, after the transition layer of the support is so poor?
It almost looks like that layers are separating for a couple of layers, then it all goes back to normal.
Is this a bug in the software or do you think hardware might be at fault?
I've just changed my Extrusion motor under warranty, but it was doing this before I did so.
Using the latest UPstudio under Beta.
Support for UP BOX and UP BOX+. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
1 post •Page 1 of 1