Page 1 of 1

printable spare parts

Posted: Fri Jan 20, 2017 4:20 am
by Furn
I have just updated up studio to 1.5.0.3 I can see the up box parts in the library but i can't open them ,what has changed from 1.3.2.1?

Re: printable spare parts

Posted: Fri Jan 20, 2017 3:20 pm
by rryerson
Why did you feel the need to post basically the same question twice?

Re: printable spare parts

Posted: Fri Jan 20, 2017 7:39 pm
by Furn
because this is the first time i have used this forum and unlike all other forums that i use where posts appear straight away ,i did not realize that posts had to be approved by a moderator and i thought i had not submitted the first one properly so in reality the mod should of seen they were both the same and only allowed one to be posted.

Re: printable spare parts

Posted: Tue Mar 13, 2018 12:24 pm
by zeeb84
rryerson wrote:
Fri Jan 20, 2017 3:20 pm
Why did you feel the need to post basically the same question twice?
Rather,
Why does FURN owe RRYERSON any explanation at all. I was able to determine that without the further explanation, AND even if I couldn't, the fact that FURN posted twice is inconsequential to my life...grow up RRYERSON

Re: printable spare parts

Posted: Thu Mar 22, 2018 5:42 pm
by Liova
The moshop is not working at all. Where can I get files for the printable parts?
I have partially melted shroud and no way to replace it, because the designs I saved are for another extruder.
Just add them to the software without any additional hops!

Re: printable spare parts

Posted: Thu Mar 22, 2018 7:49 pm
by Owen Sparks aka Marksman
I might be wrong but I think they're on the USB stick with the printers.

Re: printable spare parts

Posted: Fri Mar 23, 2018 2:32 am
by ricks01

Re: printable spare parts

Posted: Mon Mar 26, 2018 8:37 pm
by Liova
ricks01 wrote:
Fri Mar 23, 2018 2:32 am
does this help?

https://www.tiertime.com/downloads/
Thank you!
I was sure I checked it. Interestingly, https://www.up3d.com/downloads/ has no parts download and an older version of Studio.