Customised UPbox Cooler

Post improvements made for UP, and share ideas.
Post Reply
brunningm
Posts: 210
Joined: Fri Jul 21, 2017 9:44 am

Customised UPbox Cooler

Post by brunningm » Sun Feb 11, 2018 1:01 pm

HI All,

I would appreciate some input.

I've reverse engineered (Using a ruler and alot of trial and error) and customised the cooler for the Upbox.

It looks a little squarer (Can't for the life of me figure out how to use Fusion to make a curve =P ) but it fits.

It's a PLA only cooler though...can't redirect the fan just yet for ABS.

It's a first step though.

I've added the STL (RAR) and some shots of it mounted. Excuse the fact that it printed poorly. It was about the 5th time I'd printed and just ran it at 0.35 and turbo mode. It prints nicely at 0.2 and is very rigid.
Attachments
IMG_20180211_235324.jpg
IMG_20180211_235324.jpg (2.24 MiB) Viewed 2092 times
IMG_20180211_235317.jpg
IMG_20180211_235317.jpg (2.2 MiB) Viewed 2092 times
IMG_20180211_235304.jpg
IMG_20180211_235304.jpg (2.26 MiB) Viewed 2092 times
upbox cooler Customised.rar
(475.45 KiB) Downloaded 113 times

User avatar
3DWP
Posts: 189
Joined: Wed Dec 30, 2015 4:00 pm
Location: Netherlands
Contact:

Re: Customised UPbox Cooler

Post by 3DWP » Mon Feb 12, 2018 7:33 pm

Looks nice, thanks for the info and sharing! :-)

What do you mean PLA only?

brunningm
Posts: 210
Joined: Fri Jul 21, 2017 9:44 am

Re: Customised UPbox Cooler

Post by brunningm » Wed Feb 14, 2018 2:36 pm

Should have been clearer. I haven't put the latch that you open to print ABS....since you can't just turn the fan off you have to bypass it.

Post Reply