The Kustom Ktronik Printing Center

Post improvements made for UP, and share ideas.
Post Reply
ktronik
Posts: 96
Joined: Thu Apr 25, 2013 4:52 am

The Kustom Ktronik Printing Center

Post by ktronik » Mon Nov 25, 2013 12:42 am

The Kustom Ktronik Printing Center:

Temp controlled ambient air.
Negative air pressure system. (fan and filter in top of box)
Temp controlled ducted air for main board.
Carbon and dust filters.
LED lighting
12 position temp control over nozzle temp
Kustom boltless filament roller w sealed bearings
Kustom box w door

coming / not installed yet:

LED fan on main board air intake, show temp in colour.
warm side heating for temp controlled ambient air. (more a winter thing)
webcam for remote monitoring.

notes:

filament roller off the unit so to stop unit shaking the filament loose on the roll.
neg pressure system so the carbon filters work in the correct direction and kills the ABS smell, and air intake comes from outside, thru the units main board or from below air intakes near floor, both intakes thru dust filters.

Image

Image

Image

Image

Image


Now I have a good environment for printing, I can start working on UP unit itself... more soon

K

ktronik
Posts: 96
Joined: Thu Apr 25, 2013 4:52 am

Re: The Kustom Ktronik Printing Center

Post by ktronik » Thu Dec 05, 2013 11:15 am

WOW cool, I got in the UP 3D printer newsletter with me 'ducted board cooler system'...it was a bit if a spin to just be reading it then read my name... ;)

thx wackojacko and team

K

beckcopper
Posts: 5
Joined: Tue Aug 20, 2013 5:43 am

Re: The Kustom Ktronik Printing Center

Post by beckcopper » Fri Dec 25, 2015 11:24 am

How much the overall expenses for this custom products, and what items costs that much? I have few materials to use though, but do you think a type of used door just as this http://caldwells.com/exterior-doors/ will work as replacement.

Post Reply