Up Plus to skr 1.3

Post improvements made for UP, and share ideas.
Post Reply
xer00
Posts: 4
Joined: Tue Apr 14, 2015 7:29 pm

Up Plus to skr 1.3

Post by xer00 » Fri Oct 04, 2019 6:39 pm

So I was converting my Up Plus to an arduino mega + ramps that I sort of blew up and was reading about the SKR with 32bit and decided to go for that.

It's still a bit of a mess but it's working and printing pretty nicely. Next step is to add some cooling in the bottom and adjust the hole pattern so I can put it in there.

Also thinking about making another print head for bowden with an E3D V6 so I can also use more standard nozzles (the design is not finished yet just a rough model in the picture).

Here are some pictures and included the marlin configuration for if others would want to do something similar.

Image

Image

Image

My marlin 2.0 configuration.h

https://pastebin.com/W2WAmuLC

I might forget this post so if you have any questions if you try to do something similar feel free to contact me on discord Alx#4822

Post Reply