[Bug Report] Slicing Preview Slider Bar faulty at end

[BigE79]

This is only a minor bug but when previewing the print I can't inspect the last few layers of the print. The slider bar towards the end seems to jump to the last layer too early and all of the last positions on the bar only show the last layer(layer number is shown correct).
A model I'm looking at now has 960 layers: I can't preview any layers between 930 and 960 because of the jump.

This does not seem to be effected by the model or layer height or any other settings. It's always the last percentage of the preview.
This does not effect the print itself, only the preview.

Using Up Studio 2.5.32.461

[Tiertime-Joseph]

Hi BigE,

This bug will be fixed in the new release coming up very soon.

Joseph

[BigE79]

Seems to be fixed in 2.6.4.627(Beta)