[feature request] G-code print: support M300 (play beep sound) command

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
aleyush
Posts:21
Joined:Fri Feb 23, 2018 9:20 pm
[feature request] G-code print: support M300 (play beep sound) command

Post by aleyush » Thu Apr 19, 2018 5:53 am

According to the list here, now M300 command support is not implemented.

I am sure it is not complicated, according to this thread G-code transcoder did emplement this.
Top
Post Reply

Return to “UP Software”