Page 1 of 1

UP studio

Posted: Tue Apr 10, 2018 12:06 pm
by ming
I finally got around to try UP studio as my UP 2.18 has been very reliable
BUt i was not able to as i cant seem to find the Move platform command in UP STUDIO - IS it available ?
Scenario - Post initilizing the PrintBed is all the way in the back and i usually move it to center and heat it up and then move to front to load my glass and glue plate and then start the load model

Is it something i have to do to get the platform to move to the front so i can load my glass

Thanks in advance