[feature request] Manual Bed-Level Increments

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
brunningm
Posts:210
Joined:Fri Jul 21, 2017 9:44 am
[feature request] Manual Bed-Level Increments

Post by brunningm » Wed Mar 21, 2018 8:25 am

Hi TT,

When fine-tuning my bed levelling, I often wish that I could raise it by 0.05, instead of a 0.1 change.

Ordinarally, this might not be too much of an issue with a perf board, but I'm attempting to print on a PEI sheet, and it needs just a little more fine-tuning.

Post Reply