Going to say thanks for finally adding this heavily requested feature!
No more 2nd guessing about supports on overhangs on Up Studio prints (now, fix Gcode for us older UP! users for more fine-tuned prints!)
[EDIT]Also there's a basic supports editor now? (If this was taking your time on fixing gcode for us, you could have told us!)
Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
1 post •Page 1 of 1
- Screen Shot 2018-01-28 at 9.21.34 AM.png (206.74KiB)Viewed 2854 times