[Feature Request] Minimum Layer Times

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Joined:Fri Jul 21, 2017 9:44 am
[Feature Request] Minimum Layer Times

Post by brunningm » Sat Sep 16, 2017 5:47 am

Hi Team,

Can we look into getting a minimum layer time setting?

If printing small surface areas that are quite tall, the material doesn't have enough time to cool, giving the print a runny bubbled appearance.

Though, it appears we may eventually have gcode support with this sort of thing being configurable, but if not, this would be a good, small change, allowing for neater prints.

Post Reply