Page 1 of 1

0% Support material??

Posted: Fri Feb 24, 2017 11:18 am
by Stefan
I am using the older software with my Up Mini (very reluctant to go to Studio) and I want there to be an option to print without support.

Can this feature please be implemented?!

Re: 0% Support material??

Posted: Fri Feb 24, 2017 7:48 pm
by ricks01
It is already there,

Print/Preferences/Setup

In the Support section under Area select "ONLY BASE"

Re: 0% Support material??

Posted: Sun Feb 26, 2017 8:37 am
by Stefan
ricks01 wrote:It is already there,

Printer/Preferences/Setup

In the Support section under Area select "ONLY BASE"
That only looks to be in Studio not the original software.

Re: 0% Support material??

Posted: Sun Feb 26, 2017 3:58 pm
by Woodlake
Nope, its definitely there - as per Ricks post:
Print/Preferences/Support/Area (drop down list)