When trying to print raftless (at 0.3 layer height), it slices 169 layers but only sends 162 to the printer. When it starts printing, it skips the first 1-2mm of the model, printing at the next layer. So the bottom of my print is missing and the print is a failure. It looks like the way the software prints raftless is to just push the sliced model into the print bed so it cuts off the raft but this calculation is off.
The software also keeps asking me to close the door when the door is always closed.
I'm using the Up! Box.
Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
1 post •Page 1 of 1