[Bug Report] Up Studio 1.2.4 macOS "Nozzle to cold"

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Joined:Wed Jun 29, 2016 12:37 pm
[Bug Report] Up Studio 1.2.4 macOS "Nozzle to cold"

Post by Blutgeist » Wed Oct 19, 2016 9:10 am

I wanted to print a cube with Studio 1.2.4 with the UP! MINI (with new nozzle V5) under macOS Sierra. But after the data loading, it heats the nozzle correctly to the right PLA temperature but then the printboard goes only one third up stays there and it comes to the message Nozzle to cold. I can see that the temperature goes slowly down.
Testet with a old 3D UP Software 2.1 (not Studio) it prints normally...


UPDATE!!! With Version 1.3.1 the nozzle to cold bug is gone!

Post Reply