Platform calibration: locations greyed out?

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Joined:Sat Dec 20, 2014 3:26 pm
Platform calibration: locations greyed out?

Post by andif62 » Sun Dec 21, 2014 9:21 am

Hi there,

got my up! mini yesterday and now trying to get used to it.
Using it with the latest Windows software 2.13.
When I am doing the platform calibration I can only set the platform with the two green arrows.
The pull-down menus on the 9 platform points are greyed out.
I can press the numbers and the correspondig platform point will drive under the nozzle.
But no way to change the value of this specific point.
Shouldn´t it look like this: ... &Itemid=55?

Post Reply