[BUG REPORT] V2.0 - Missing support material.

Support for UP Software. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
cj7hawk
Posts:103
Joined:Tue Dec 25, 2012 7:52 am
[BUG REPORT] V2.0 - Missing support material.

Post by cj7hawk » Tue Sep 24, 2013 12:37 pm

Just hit a support calculation bug on v2.0 - was printing a symmetrical ( and orthagonally symmetric to the print bed ) part and it missed some support entirely, printing in mid-air. :(
basebug.jpg
Detail.
basebug.jpg (16.98KiB)Viewed 3955 times
The base support on one side is shorter than the other, yet the part is symmetrical. It's easier to see from underneath when the picture is rotated. I also moved it 20 right and forward before printing.

What other information should I provide to assist in locating the fault ( look at the ends of the "arms" - one is not covered by the base - this printed in mid-air )

Thanks
David
Attachments
basebug.jpg
basebug.jpg (16.98KiB)Viewed 3955 times

Post Reply