Surface Mode

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Joined:Wed Nov 13, 2013 10:40 am
Surface Mode

Post by EM-creations » Fri May 01, 2020 12:56 pm

So after some years I decided to use my Up! Mini again.

Like before I stick with Up! V2.18, now if I want to print following model (scaled down) in ABS: Twisted 6-sided Vase Basic ( can I do this using Surface Mode or isn't that possible?

Because I read: "With surface mode, it will print a model only 1 layer thick with no internal fill. It will also not create a flat bottom surface or the top flat surface." Does this mean I'll end up with a twisted tube instead of a vase?

Post Reply