Help needed

Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
Posts: 2
Joined: Tue Dec 25, 2018 10:04 pm

Help needed

Post by falcon12 » Tue Dec 25, 2018 10:56 pm


My UP Mini 2 printer sometimes goes into "displacement error" number 5.
I also have a nozzle detection problem during calibration: the tray goes up
but the nozzle is not detected and I have to turn off the printer.

I have attached a picture of the board with this message. I do not understand what the piece marked "piece A" is for. Is she in her normal position? Is it normally in position 1, in position 2?
Is she crooked? Does this room have a link to my problems?

Thank you for any help.
ImageBugMiniUP2.jpg (605.93 KiB) Viewed 2748 times

Posts: 101
Joined: Tue Oct 16, 2018 8:25 am

Re: Help needed

Post by TiertimeBrook » Wed Dec 26, 2018 1:25 am

Hello ,
The piece A has bent on your printer, It should be a flat piece,The detection will done when the piece A touched the screw (B in follow attachment),
That is why your got the detection problem.try to adjust it manually.
mini2.jpg (47.05 KiB) Viewed 2744 times

Post Reply