Hi All, thought I would pass on my experiences with my Mini.
Firstly I'm using a glass print bed. One of these, slides right in, and although slightly longer, it hasn't caused an issue for me, just centre it on the platform.
http://www.ebay.com.au/itm/LearCNC-140x ... 0941255643
Im yet to figure out the best way to setup for raftless printing, I need a guide!
I have also added an 80 degree thermistor to help with bed temps, this seems to be doing a great job along with some blue painters tape.
Next mod will be a 60/80/100 degree switch for all print types.
This has helped enormously with my ABS prints, Im going to delve into PLA now and see if I can actually get my first print happening. (Clunk clunk clunk etc)
Support for UP mini. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
2 posts •Page 1 of 1