Page 1 of 1

Up Mini Extruder chip

Posted: Fri Dec 11, 2015 3:42 pm
by Numonic
Hi does anyone out there have this chip or know whats going on with my extruder? I was printing out a replacement windbarrier and used Windbarrier V1.19.UP3
it worked perfectly. But after doing so my machine wont heat up or extrude.

Re: Up Mini Extruder chip

Posted: Fri Dec 11, 2015 4:46 pm
by Numonic
Got it to work again thank God :D must've been a lose wire or something took it apart several times and it worked again.

Re: Up Mini Extruder chip

Posted: Fri Dec 11, 2015 6:35 pm
by brainzilla
It's just a segment of 12V LED-stripe.
You can buy those for a few bucks - in 5m rolls :-)

Re: Up Mini Extruder chip

Posted: Fri Dec 11, 2015 6:40 pm
by Numonic
Thanks brainzilla i looked it up and found out. :lol: