Fitting enclosure

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
Bcarv
Posts: 5
Joined: Sat Jun 18, 2016 1:49 am

Fitting enclosure

Post by Bcarv » Tue Jun 28, 2016 10:30 pm

Okay, here is a silly question.
Can I safely remove three of the four bolts on the left hand side of the printer to install a spool holder compatible with an enclosure I have purchased? These would then got back holdings spool holder in place and the enclosure.
Forgive my ignorance - I don't want to wreck my printer.
Cheers, BC


Post Reply