Enclosure?

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Bcarv
Posts:5
Joined:Sat Jun 18, 2016 1:49 am
Enclosure?

Post by Bcarv » Sat Jun 18, 2016 2:16 am

Hi,
I purchased a second hand UP 2d plus about a month ago and am quite pleased with my results so far. I am running it from an old Pc laptop to take advantage of Fix Up hack. I have used only ABS but have experienced some warping and lifting on some prints. Should I invest in an enclosure ? Either build one from scratch or try this one http://3dprintersuperstore.com.au/produ ... at-chamber
Anyone have experience with this?
Cheers,
Brett

Post Reply