Troubleshot printing

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
User avatar
tridament
Posts: 11
Joined: Sat Sep 05, 2015 9:38 pm

Troubleshot printing

Post by tridament » Thu Oct 29, 2015 1:17 pm

Hello,

So I print ABS without any problems, but I cannot print PLA. It does first raft layer and after moving to another position it will just stop printing.

Any advices?

mb20music
Posts: 375
Joined: Thu Feb 14, 2013 1:35 am
Location: USA

Re: Troubleshot printing

Post by mb20music » Thu Oct 29, 2015 1:37 pm

Are you using the UP! or Afinia OEM brand PLA? or an aftermarket third party PLA filament?

User avatar
tridament
Posts: 11
Joined: Sat Sep 05, 2015 9:38 pm

Re: Troubleshot printing

Post by tridament » Thu Oct 29, 2015 1:54 pm

I am using third party filament, I have already printed with this PLA, but after switching back from ABS. it does not want to print anymore

EDIT/ I tried to clean nozzle, basically everything. But it only prints first layer, then i have to withdraw filament and put it again

User avatar
DrewPetitclerc
Posts: 580
Joined: Sat Feb 12, 2011 7:39 am
Location: Silicon Valley California
Contact:

Re: Troubleshot printing

Post by DrewPetitclerc » Thu Oct 29, 2015 11:49 pm

You should try reading my posts, they apply to your issues.
http://www.pp3dp.com/forum/viewtopic.ph ... =753#p5473

Regards
Drew
Drew Petitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc

Post Reply