Replacement for Autolevel Sensor

[dsk0l]

Hello everyone,

I recently shipped off an Up! Plus 2 to a colleague in a different country, and the autolevel/platform height sensor seems to have been lost somewhere along the way. While it's not critical for printing, the new operator of the printer would be better off with the sensor since he is untrained on leveling the bed manually.

PP3DP doesn't sell them, and while I know it wouldn't be difficult to make one, I don't have the printer any more and asking my colleague to figure it out would be too much of a hassle. Does anyone know where I could get a replacement sensor (i.e. plastic part + switch + aux cable)?

Thanks in advance!

David