Up Plus 2 Moving out of alignment

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
alanastra
Posts: 1
Joined: Sat Jun 21, 2014 2:16 pm

Up Plus 2 Moving out of alignment

Post by alanastra » Sat Jun 21, 2014 3:33 pm

Hi, I've had my printer for about a week now and all was ok until yesterday when it started printing out of alignment. It printed the first layer, then moved to print the second and again for the fill, then stayed steady for a bit and moved again printing in mid air. Sometimes it starts off fine and then moves for no reason. Does anyone know what could be happening because I'm going to have to send it back otherwise since I've only had it a week.

Post Reply