Nozzle goint to far in all the X and Y direction

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
Marbla
Posts: 10
Joined: Sat Feb 16, 2013 6:29 pm

Nozzle goint to far in all the X and Y direction

Post by Marbla » Sat Feb 23, 2013 9:08 am

Hi!

My nozzle is moving to the far corner in every direction when I'm in maintance and when printing. This makes it hard to place the clips to hold the Perfboard because the nozzle is crashing into them. It's not the biggest deal because my prints are always in the middle but it wasn't like that before so it probably isn't suposed to be like that.

Thanks for your help.

Post Reply