Help/advice with Bed not raising

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
gnomadix
Posts: 8
Joined: Mon Oct 28, 2013 2:52 pm

Help/advice with Bed not raising

Post by gnomadix » Mon Dec 09, 2013 3:18 pm

Dear All,

I was hoping to get some advice
I was trying to tape down a curling print and accidentally
put too much weight on the bed (but not a lot)and it dropped
after that the bed would not lift more than 10-15mm when
initialized

Does any one have any experience of this: it is something I can fix?
or will I have to send it back to the suppliers (denford uk)

Many Thanks
Simon

Tiertime-Edward
Posts: 206
Joined: Tue Sep 07, 2010 9:15 am

Re: Help/advice with Bed not raising

Post by Tiertime-Edward » Tue Dec 10, 2013 4:13 am

Hi Simon, can you move the platform up by software, like move to 120mm height? During initialization, the platform just moves up a little bit. After you initialize the printer, it will find its zero point. If you platform can be moved up smoothly, then it has no problem.

Post Reply