Adjust print bed height for Gekko boards?

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
MacroMeez
Posts:4
Joined:Fri Nov 08, 2013 6:39 am
Adjust print bed height for Gekko boards?

Post by MacroMeez » Mon Dec 02, 2013 12:07 am

I noticed in the thread about the gekko boards that a couple people mentioned they had to adjust the print bed height or else it would gouge into the gekko board. I assumed this meant using the auto-level and nozzle height features of the Up software, but i was wrong, so now i have an engraved gekko board. I went back to the perf boards and they still work fine, but I'd love to use these gekko boards. Can anyone tell me more about how to adjust the nozzle height correctly to use the gekko board with the heat shield?

Post Reply