Z axis only moves up.

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
Linkreincarnate
Posts: 137
Joined: Wed Aug 11, 2010 5:37 am

Z axis only moves up.

Post by Linkreincarnate » Sun Jun 09, 2013 12:52 am

This has been brought up before and the person was told to trace their lines. I have looked everywhere and none of my wires are cut or frayed. If I open it up and press the buttn on the cpu board it fixes itself for a short time until it begins acting up again.

roller
Posts: 1622
Joined: Sat Oct 06, 2012 9:09 pm
Location: Brisbane, Australia

Re: Z axis only moves up.

Post by roller » Sun Jun 09, 2013 2:26 am

There should be a switch on Z the tells it when it's at the bottom during initialise - check it's behaving properly.

Post Reply