Nozzle not heating

Support for UP Plus and UP Plus 2. To report a bug, post with a title [BUG REPORT]. To request a feature, post with a title [FEATURE REQUEST]
Post Reply
stew_mac
Posts: 2
Joined: Fri Oct 19, 2018 11:31 am

Nozzle not heating

Post by stew_mac » Fri Oct 19, 2018 11:44 am

The nozzle on my up plus 2 is not heating or is stopping during a print and the error message is “nozzle to cold”

Is there an electrical diagram so I can fault find the issue?

I would like to see if a mosfit or ribbon is damaged so I can repair it as soon as possible.

ricks01
Posts: 165
Joined: Wed Dec 30, 2015 6:07 pm

Re: Nozzle not heating

Post by ricks01 » Sat Oct 20, 2018 1:43 am

most of the time, the issue is with the wires on the temperature sensor on the nozzle heater block.

stew_mac
Posts: 2
Joined: Fri Oct 19, 2018 11:31 am

Re: Nozzle not heating

Post by stew_mac » Sun Dec 02, 2018 9:58 pm

I tested the ribbon and it all looks ok. I noticed there is no power getting to the board on top of the extruder, so I think it’s got to be the board.

Anyone know where I can get a replacement?

Post Reply