Page 1 of 1

stainless steel nozzles

Posted: Thu Feb 25, 2016 4:02 pm
by Matchpoint
anyone know of any non-brass nozzles that fit the up hot end

Re: stainless steel nozzles

Posted: Fri Feb 26, 2016 2:47 am
by tel
I was told last time I ordered a nozzle that the Up Box came with different colour nozzles on different machines. They had silver and bronze coloured ones there at the time so I assume the silver ones may be stainless steel.

Link to the store
http://3dprintersuperstore.com.au/

Re: stainless steel nozzles

Posted: Wed Mar 02, 2016 12:10 pm
by Oland
http://www.banggood.com/0_4MM-Stainless ... 12193.html

The inner bore is too small for the UP mini-extruder, so drilled to 3.5mm
outside is ok (M6)
I want to use formfutura 1.75mm "CarbonFil" they recommend SS nozzle

Re: stainless steel nozzles

Posted: Mon Apr 18, 2016 7:49 pm
by Kai
I use one from Micro-Swiss. This nozzle has a brass core and is hard plated with TwinClad XT:
https://store.micro-swiss.com/collectio ... rtrax-m200

From the reading it appears that the Zortrax M200 uses the same nozzles.

Re: stainless steel nozzles

Posted: Wed Apr 20, 2016 9:17 am
by car3less
Kai wrote:I use one from Micro-Swiss. This nozzle has a brass core and is hard plated with TwinClad XT:
https://store.micro-swiss.com/collectio ... rtrax-m200

From the reading it appears that the Zortrax M200 uses the same nozzles.

And does it work well?

I have in the office Up plus 2, Up Box and Zortrax so this nozzle would be great for all of them.
For me, from Formfutura only one type of PLA works on Up and no ABS. Didn't even bother to try Carbonfill...

Re: stainless steel nozzles

Posted: Fri Sep 23, 2016 10:09 pm
by Kai
The Twin Clad Micro Swiss Nozzle works very well, even after printing some kilograms ofAlu ABS :D