Share projects and models that you like, and wow the fellow Uppers!
3 posts • Page 1 of 1
NICE! This is perfect for my 1 kg filament.outsider wrote:Hi guys,
Just wanted to post my new filament spool holder and guide that I made for the UP! Plus.
The spool holder that comes with the printer only takes the narrow spools that PP3DP sells.
The spool holder I've created will allow for a 100mm wide spool and 250mm diameter spool to fit on the printer.
Also, since the spool holder gets replaced, a new filament guide was needed.
Both parts are heavy duty, and should last.
Check it out here: