Share projects and models that you like, and wow the fellow Uppers!
1 post •Page 1 of 1
I have a model that will not print on my Afinia 479. It used to print just fine, after upgrading the software on my Mac and I think the firmware being upgraded by Afinia when it was in for repair the printer now stops part way through the print. Other models work just fine. Wondering if someone more knowledgeable than I may be able to take a look at the model and perhaps fix it? Its a relatively small part about 1" square 100 or so layers. If you are willing to help my email is email@example.com Thanks!