Suggestions on printing this part

Share projects and models that you like, and wow the fellow Uppers!
Post Reply
ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

Suggestions on printing this part

Post by ming » Mon Apr 21, 2014 12:26 pm

Material : ABS
Temp: 100% (260C)
Mode : Normal
Base: Perf Board ??? ( Glass make not keep this part adhered ?)
Z: 0.2mm Fill: Fine

Question:
1. Orientation ?
2. Which base to use ?
Attachments
HD2.jpg
HD2.jpg (9.63 KiB) Viewed 3758 times
Dream@night / Holdit@sameday

ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

Re: Suggestions on printing this part

Post by ming » Mon Apr 21, 2014 4:22 pm

its printing live now with the following setup on perfboard
Attachments
Capture.jpg
Capture.jpg (112.85 KiB) Viewed 3751 times
Dream@night / Holdit@sameday

ming
Posts: 194
Joined: Wed Mar 12, 2014 2:06 am
Location: Georgia USA

Re: Suggestions on printing this part

Post by ming » Wed Apr 23, 2014 3:24 am

Parts came out great
Attachments
vacuum holdown.jpg
vacuum holdown.jpg (113.45 KiB) Viewed 3715 times
Dream@night / Holdit@sameday

Post Reply