Another printed 3D working machine

Share projects and models that you like, and wow the fellow Uppers!
Post Reply
jeeplvr
Posts: 212
Joined: Sat Jun 08, 2013 5:26 am

Another printed 3D working machine

Post by jeeplvr » Sun Jan 19, 2014 1:45 am

Its a multipurpose charger
USB ready.
Output - 5v dc
Hand cranked. Works good as a cell phone charger or attach a light.
Attachments
DSC02352.JPG
DSC02352.JPG (56.64 KiB) Viewed 6581 times

User avatar
Lawrence
Posts: 268
Joined: Wed May 16, 2012 12:24 pm
Location: Melbourne, Australia

Re: Another printed 3D working machine

Post by Lawrence » Sun Jan 19, 2014 2:38 am

That is a great innovation. Very nicely done.

jeeplvr
Posts: 212
Joined: Sat Jun 08, 2013 5:26 am

Re: Another printed 3D working machine

Post by jeeplvr » Sun Jan 19, 2014 6:19 am

Lawrence wrote:That is a great innovation. Very nicely done.
Thanks. I thought I posted more pictures than just one.
Attachments
DSC02351.JPG
DSC02351.JPG (32.08 KiB) Viewed 6563 times
DSC02350.JPG
DSC02350.JPG (33.92 KiB) Viewed 6563 times
2014-01-18 15.06.32.jpg
2014-01-18 15.06.32.jpg (66.37 KiB) Viewed 6563 times

jeeplvr
Posts: 212
Joined: Sat Jun 08, 2013 5:26 am

Re: Another printed 3D working machine

Post by jeeplvr » Sun Jan 19, 2014 6:28 am

This 1st prototype is printed in fast mode so it is a little rough. I always print that way until the design is just right. The business end consists of a small 3 phase ac dynamo, 3 phase rectifier that I built myself, and a dc charging buck board with a USB port. I do all my own designs and it's all from scratch.

jeeplvr
Posts: 212
Joined: Sat Jun 08, 2013 5:26 am

Re: Another printed 3D working machine

Post by jeeplvr » Sun Jan 26, 2014 8:37 am

A short video of the charger working.

https://www.youtube.com/watch?v=fYcMc6--GSE

Post Reply