Page 1 of 1

Lookey what I made

Posted: Mon Jan 06, 2014 7:01 am
by jeeplvr
Its a fully functional Dynamo Light made with an UP Mini.
I have two working models.
734101_185975171607866_207064040_n.jpg
734101_185975171607866_207064040_n.jpg (26.51 KiB) Viewed 6240 times

Re: Lookey what I made

Posted: Mon Jan 06, 2014 7:08 am
by jeeplvr
And the first test of the first prototype.
http://youtu.be/XNj1datjETQ

Re: Lookey what I made

Posted: Mon Jan 06, 2014 12:17 pm
by ftdesigns
that's pretty sweet. did you also print the bearing?

Re: Lookey what I made

Posted: Tue Jan 07, 2014 3:35 am
by wackojacko
Just sent you a PM

Re: Lookey what I made

Posted: Tue Jan 07, 2014 5:16 am
by jeeplvr
ftdesigns wrote:that's pretty sweet. did you also print the bearing?
The bearing is steel and was purchased. The only things not printed were the bearings, screws, wires, LED's, and the dynamo (generator). The housings, gear, handle, chain drive, and covers were all printed from ABS. I designed the entire thing in Solidworks.