Hi all,
Just wanted to share one of my prints that came out fairly nice. The base design for the dragon comes from one of my favorite series, The Wheel of Time, by Robert Jordan. Please note that the base design and all that are owned by Tor.
I am loving the Up!
It looks fairly good when backlit in a window:
Here is an iso view:
And a front view:
WOT Dragon
- DrewPetitclerc
- Posts:581
- Joined:Sat Feb 12, 2011 7:39 am
- Location:Silicon Valley California
- Contact:
Re: WOT Dragon
Very nice, but change the Z of the three surfaces and you can "pause" the print and change the colors at each layer and it really makes things POP in color.
But still really nice.
But still really nice.
Drew Petitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc
Petitclerc Designs
Owner/Senior Principal Designer, prototype, tooling and test equipment design and 3D printing
http://flash-graphics.deviantart.com/
http://www.thingiverse.com/DrewPetitclerc
Re: WOT Dragon
I like how the top fill pattern has created a cool texture on the Dragon. Very nice!
Re: WOT Dragon
Thanks, I'll keep that in mind. Guess I need to invest in the Petitclerc Feeder MechanismDrewPetitclerc wrote:Very nice, but change the Z of the three surfaces and you can "pause" the print and change the colors at each layer and it really makes things POP in color.
But still really nice.
