Non Support sculpting test!

Share projects and models that you like, and wow the fellow Uppers!
Post Reply
jspark
Posts: 60
Joined: Thu Aug 02, 2012 8:20 am
Contact:

Non Support sculpting test!

Post by jspark » Thu Aug 16, 2012 10:55 am

Hi~
I was tried to sculpt the model without support.
It was great!

Image

Image

20120805_triangle_110mm.stl

eyUP
Posts: 230
Joined: Thu May 24, 2012 3:23 pm

Re: Non Support sculpting test!

Post by eyUP » Thu Aug 16, 2012 12:59 pm

Those look great !
What angle was the support set to ? 10degrees ?

jspark
Posts: 60
Joined: Thu Aug 02, 2012 8:20 am
Contact:

Re: Non Support sculpting test!

Post by jspark » Thu Aug 16, 2012 6:52 pm

I designed all elements of the model have 45 degree of angle.
And I used support setting of 30 degree! Thanks! :)

User avatar
wilsonj
Posts: 569
Joined: Tue Feb 28, 2012 10:26 pm
Location: Australia

Re: Non Support sculpting test!

Post by wilsonj » Thu Aug 16, 2012 9:11 pm

Very nice ! Do they stack together ? And what are they for ?
Regards
Jamie
3DPrinterGear.com.au

juancr
Posts: 90
Joined: Sat Jul 28, 2012 10:19 am
Location: Spain
Contact:

Re: Non Support sculpting test!

Post by juancr » Fri Aug 17, 2012 6:57 am

Nice job!! :mrgreen:
Regards,
JuanCR
(You should know I do my best with my written english ;-) )

jspark
Posts: 60
Joined: Thu Aug 02, 2012 8:20 am
Contact:

Re: Non Support sculpting test!

Post by jspark » Sat Aug 18, 2012 4:13 am

wilsonj>> Yes. It's stackable. There are holes bottom of the model. It's just for tesing. :D
juancr>> Thanks! :mrgreen:

Post Reply