Page 1 of 1

Longest one load print

Posted: Wed Mar 13, 2013 12:45 pm
by Liutauras
What is your longest, one load, successful print? Mine, with UP!Plus, was 22 hours and 16 minutes. 0.15 layers, loose, with raft, 150.9g of material. Right after that Plus made second one 22 hours print, same options, 149.6g material usage. 8-)

Re: Longest one load print

Posted: Fri Mar 22, 2013 5:10 pm
by Marbla
Mine was probably the Airship: ( http://www.thingiverse.com/thing:45295 ). I think I printed one or two halves and other pieces. I remember printing sometin more for it but I don't remember which piece. It took a little over 9 hours on 0.15, Fine.

I also wanted to print the Voronoi Yoda: ( http://www.thingiverse.com/thing:44505 ) as one of my first prints but it was supposed to take 33 hours. It's probably because the support setting were on everything and I'm still scared to risk the time for failure.

Speaking of which, has anyone managed to print the Voronoi Yoda on the UP! Plus? What settings did you use?