Page 1 of 1

Nearly perfect sphere

Posted: Wed Aug 21, 2013 7:14 am
by amd-tec
Not new idea, but might be usefull in some cases.

Inspired by this http://www.thingiverse.com/thing:135716 I printed sphere with block support.
There is a 0.2 mm gap between block and sphere. Printed with 0.15 mm layer and fine mode.
Arrows shows the bottom side which is usually the hard side to print...

Thanks,

amd-tec

Re: Nearly perfect sphere

Posted: Wed Aug 21, 2013 7:39 am
by wackojacko
If you print with the wind barrier open the under side curves are much better

Re: Nearly perfect sphere

Posted: Wed Aug 21, 2013 11:04 am
by amd-tec
wackojacko wrote:If you print with the wind barrier open the under side curves are much better
In those prints wind barrier was half open, here`s the results when wind barrier is fully open. The settings was same.
It`s closer but still "far" away.