Welcome to 2019!

New user in this forum can introduce yourself here. Pictures of new UP Printer, fresh prints from UP Printer, and more.
Post Reply
Posts: 1
Joined: Sat Jan 05, 2019 5:05 pm

Welcome to 2019!

Post by Davidthepcguy » Sat Jan 05, 2019 5:06 pm

Hey everyone!
I just started 3d printing!

Quick question - The first layer of my raft is always too close to the bed.
What should I set my Nozzle Height Adjustment (Z Height) to so that filament comes out on the first 2 layers?

Posts: 101
Joined: Tue Oct 16, 2018 8:25 am

Re: Welcome to 2019!

Post by TiertimeBrook » Mon Jan 07, 2019 1:15 am


Try manully set the nozzle height to a 0.1mm(a4 paper thickness) before your printing and ensure you print with a raft.


Post Reply